Annicom Axio Logo  
    +44(0)1420487788  
 
home | about us | products | datasheets | account
 
   
datasheetdetails
 <<  |  <  |   DH-1 - Duct Humdistat
DH-1/50 / DH-1/24V/196 Duct Humidistat 196mm probe (50mm & 20mm Probe) POA Qty
DH-1/50 / DH-1/196 Duct Humidistat 196mm probe POA Qty
DH-1/50 / DH-1/24V/50 Duct Humidistat 50mm probe (100mm & 200mm Probe) POA Qty
DH-1/50 / DH-1/50 Duct Humidistat 50mm probe POA Qty
 <<  |  <  | OVERVIEW | SPECIFICATION | DATASHEETS        

The DH-1 duct humidistat delivers accurate electronic control of humidity levels in HVAC ventilation ducts. Capable of switching loads of up to 10A at 250V AC, it is ideally suited to the control of ventilation, humidification and dehumidification equipment; such as extract fans, boost controls, override controls, alarms, etc. The duct humidistat is powered from a 24V AC or DC supply.
Product Features
• The DH-1/24V is calibration-free and accurate to within 3% RH. The high-accuracy humidity sensor is housed in a robust, corrosion-proof 100mm* probe, delivering consistent accuracy and maintenance free** operation.
• The DH-1/24V regulates to a fully adjustable relative humidity set-point between 5% and 95% and a relative humidity hysteresis (differential) which is fully adjustable between 1% and 10%.
• The duct humidistat design allows for easy installation directly to the exterior of flat-sided ductwork using self-tapping screws. A 16mm dia hole will be required for the humidity sensor probe to protrude through into the duct. The unit comes complete with a cable gland in the base for tidy and secure cabling. Alternatively if direct connection to electrical conduit is desired, this may be removed and exchanged for a suitable conduit connector (with M20 thread).

Power supply
220V - 240V AC 50Hz (live/neutral)
Output switch rating
10A, 250V AC 50Hz (resistive)
Output switch type
Changeover relay (volt-free)
Cable entry
Pre-fitted M20 gland, for 5 to 13mm dia. round cable
(remove reducer insert for >7.5mm).

May be exchanged for a M20 conduit connector

Humidity control
5% RH to 95% RH
Humidity differential
1% RH to 10% RH
Sensor accuracy
+/- 3% RH
Sensor drift
+/- 1.2% RH over 5 years (no calibration required)
Probe length (standard)
200mm (sensing element 178mm from base)
Guarantee
5 Years
Weight
210g
Dimensions (with standard probe)
109mm x 82mm x 258mm
Country Of Origin
UK

DH-1.pdf / Duct Humidistat